I was thinking that with my old Craft Robo software, I could make my design out of different color lines and then tell it to cut just the color I wanted to. But I can't figure out how to do that with my Silhouette. Does anyone know if that can be done?

Hi Laurianne

Sorry for the late response, but just secured employment after 9 months Un-Employment and this was my first week of 9-5 and I can say its been truly exhausting; its a 3 year project and its mentally challenging. I think the following example is what you were asking about.....Be back in a minute...OK I think this is your answer Laurianne.

Thank you Angel. I sure hope your new employment is just the right challenge for you! I know it is exhausting to start on a new venture.

I haven't had a chance to look at your instructions yet as we just arrived back home after being out of town for my FIL's funeral. This has been quite the summer for us. But I look forward to checking this out as I have been a little frustrated with not knowing how to do this.

Thanks again.