Inkscape for Cutting Design

Inkscape Tutorials => Inkscape Tutorials - Intermediate => Topic started by: Aussie Carolyn on May 18, 2012, 08:48:31 AM

Title: Ideas for using Extrude
Post by: Aussie Carolyn on May 18, 2012, 08:48:31 AM
An easy tutorial showing the basic steps to create projects using extrude. I will leave it up to you to experiment and see what type of designs you can create.

 [ You are not allowed to view attachments ]

A few ideas for you to try
- if the shape is symmetrical flip it horizontal or vertical. It will look the same but the extrude result will be different.
- try more than two shape
- place shapes side by side and even use the same size shapes.
Give it a try and you may be surprised at the designs you can create in a few minutes.

 [ You are not allowed to view attachments ]

 [ You are not allowed to view attachments ]

 [ You are not allowed to view attachments ]

 [ You are not allowed to view attachments ]

Do not repost this tutorial on any other website or claim the written instructions as your own.
Title: Re: Ideas for using Extrude
Post by: PapaSue on May 18, 2012, 10:02:29 AM
I'm on it.  I'll post what I've done so far in the "altered" categor as, per usual, I did it with a twist.  Just can't leave good enough alone.
Title: Re: Ideas for using Extrude
Post by: scud on May 18, 2012, 06:02:09 PM
Thanks Carolyn. I've saved it and one day will have a go.
Barbara