• September 22, 2019, 07:42:04 PM
• Welcome, Guest. Please login or register.

The Future of this Forum:

The Inkscape Project opened its first official forum on its website this month (August 2019). https://inkscape.org/forums/ In an effort to combine all the different forums into one, this forum will no longer be accepting new members or new messages. However, it will remain open for a little while, for existing members, to have access to their contents, if they need them.

Any potential new members should register on the new forum, and post their message there. There is a special board for questions about using Inkscape for cutting machines (of all kinds). (https://inkscape.org/forums/cutplot/)

If you have any questions or comments (and you're an existing member) you can post them here.

Although I've been planning to put this forum in read-only mode, at the time of this transition, unfortunately, my personal circumstances have changed, and I won't be able to host this forum much longer. I'm not sure about the time frame. It could be as soon as the end of 2019, or as long as a year from now. If anyone is interested in taking it over, please contact me.

-- brynn


Contact

Your Name:
Subject
Message

Please do not use this for Inkscape support. Please register and post your question in the forum. If you have trouble registering, please use this form.

Verification:
Type the letters shown in the picture
Request another image

Type the letters shown in the picture:
If you're colorblind, refresh the page to get a different challenge.  This is one very easy way to make multiple selections."You can select any number of objects simultaneously by Shift+clicking them. Or, you can drag the mouse around all the objects you need to select; this is called rubberband selection.  Please write the 1st letter of each green word, in order, without any spaces, in the box.:
Email Address

Powered by Contact Page