• September 18, 2019, 02:51:43 PM
• Welcome, Guest. Please login or register.

The Future of this Forum:

The Inkscape Project opened its first official forum on its website this month (August 2019). https://inkscape.org/forums/ In an effort to combine all the different forums into one, this forum will no longer be accepting new members or new messages. However, it will remain open for a little while, for existing members, to have access to their contents, if they need them.

Any potential new members should register on the new forum, and post their message there. There is a special board for questions about using Inkscape for cutting machines (of all kinds). (https://inkscape.org/forums/cutplot/)

If you have any questions or comments (and you're an existing member) you can post them here.

Although I've been planning to put this forum in read-only mode, at the time of this transition, unfortunately, my personal circumstances have changed, and I won't be able to host this forum much longer. I'm not sure about the time frame. It could be as soon as the end of 2019, or as long as a year from now. If anyone is interested in taking it over, please contact me.

-- brynn


Author Topic: Robomaster Software Tool Bar Icons.......  (Read 2060 times)

0 Members and 1 Guest are viewing this topic.

Offline Angel13

  • Original Member
  • *****
  • Posts: 635
  • Country: 00
    • http://cardsulike.blogspot.com/
Robomaster Software Tool Bar Icons.......
« on: July 25, 2010, 07:27:44 PM »
It was pointed out too me that people following the instructions for the Robomaster part of the pictorial, maybe helped more if there was an explanation of the Tool Bar icons. So I have provided a downloadable pictorial of the Robomaster Tool Bar Icons.......

The picture attached also shows how you can change the page measurements, in the Robomaster software from inches into millimetres or mm to me and you.

« Last Edit: December 31, 1969, 05:00:00 PM by Guest »
http://cardsulike.blogspot.com/
http://www.craftsuprint.com/default.cfm?designer=379

Windows Vista, Silhouette Cutter same as Craft Robo(Mini Expert) Cameo Beginner, Inkscape, Cougar(Learning curb going on!!)